Roadmaster RM3477 Manuel du propriétaire Page 1

Entire contents of manual must be read by ownerTowing and Suspension SolutionsROADMASTER, Inc. • 6110 NE 127th Ave • Vancouver, WA 98682800-669-96

rear wheels, or severe brake damage or fire may result. 9. Re-install the pivot pin and properly secure with the safety pin (see Figure 3).

tered on the dolly. In an empty parking lot, have someone watch as you slowly turn sharply to see whether you have this potential problem.

10MAINTENANCE 1. Torque the wheel lug nuts to 90 ft./lb. Check and maintain every 3,000 miles or every six months. 2. TieDown™ ratchets — che

Even though they may appear to be identical, one TieDown strap is designed for the driver’s side and the other for the passenger side. Alt

1. WARRANTY 1a. WARRANTY OF CONFORMITY AT TIME OF SALE ROADMASTER, Inc. warrants that at the time of sale of this product it will be free from def

13Spare tire and wheel This optional spare tire and wheel eliminates costly delays and flat tire hassles. Heavy-duty ST 215/75 R14 radi

 Coupler is securely latched to trailer ball. Safety chains are attached to motorhome. Electrical harness is plugged into motorhome, and dolly l

This manual has been prepared to acquaint you with the assembly and operation of your tow dolly, and to provide you with important safety information.

Specifications ...inside front coverSafety Definitions ...inside front coverTow Dolly Safe

Read all instructions before assembling or op-erating the tow dolly. Failure to understand how to assemble or operate the tow dolly coul

Read all instructions before assembling or op-erating the tow dolly. Failure to understand how to assemble or operate the tow dolly coul

Although it is not necessary, it may be more conve-nient to attach the brake drums, fenders and wheels if the axle is supported with three jack st

INITIAL ASSEMBLYflat washers (both sides) and nut to attach the two stabilizer bars to the pre-drilled holes in the tongue, and the

tighten the bolt further. Repeat until the ramps do not tilt down. Then, loosen the bolt slightly and test to see if the ramps tilt down. When t

Before Loading 1. Before loading the towed vehicle, make certain that the ramps have been adjusted to correspond to the width of the towed v